Fill of container.

  1. Law
  2. CFR 7
  3. Agriculture
  4. Regulations of the Department of Agriculture
  5. Agricultural Marketing Service (Standards, Inspections, Marketing Practices), Department of Agriculture
  6. Requirements and Standards Under the Agricultural Marketing Act of 1946 and the Egg Products Inspection Act
  7. Processed Fruits and Vegetables, Processed Products Thereof, and Certain Other Processed Food Products
  8. United States Standards for Grades of Canned Red Tart Pitted Cherries
  9. Fill of Container
  10. Fill of container.

Checkout our iOS App for a better way to browser and research.

§ 52.774 Fill of container.

(a) FDA requirements. Canned red tart pitted cherries shall meet the fill of container requirements as set forth in the regulations of the Food and Drug Administration (21 CFR 145.125(c)).

(b) Recommended minimum drained weights -

(1) General. The minimum drained weight recommendations for the various container sizes and types of packing media as listed in Table I of this section are not incorporated in the grades of the finished product since drained weight, as such, is not a factor of quality for the purpose of these grades.

(2) Definitions.

Sample average - Average of all the drained weights of the sample containers representing a lot.

Xd - A specified minimum sample average drained weight.

LL - Lower limit for individual container drained weight.

(3) Method for ascertaining drained weight. The drained weight of canned red tart pitted cherries is determined by emptying the contents of the container upon a U.S. Standard No. 8 circular sieve of proper diameter containing eight meshes to the inch (0.0937 inch (2.3 mm), ±3 percent, square openings) so as to distribute the product evenly over the sieve. Without shifting the product, incline the sieve at an angle of 17° to 20° to facilitate drainage and allow to drain for two minutes. The weight of drained cherries is the weight of the sieve and product less the weight of the dry sieve. A sieve eight inches in diameter is used for No. 3 size containers (404 × 414) and smaller, and a sieve 12 inches in diameter is used for containers larger than No. 3 size containers.

(4) Compliance with recommended minimum drained weights. A lot of canned red tart pitted cherries is considered as meeting the minimum drained weight recommendations when the following criteria are met:

(i) The sample average meets the specified minimum sample average drained weight (designated as “Xd” in Table I); and

(ii) The number of sample containers which fail to meet the minimum drained weight for individual containers (designated as “LL” in Table I) does not exceed the applicable acceptance number specified in Table II.

(c) Recommended fill weights -

(1) General. The minimum fill weight recommendations for the various container sizes in Table III of this section are not incorporated in the grades of the finished product since fill weight, as such, is not a factor of quality for the purpose of these grades.

Expand Table

Table I - Recommended Minimum Drained Weights for Canned Red Tart Pitted Cherries

Container designation Packed in water or cherry juice (ounces) Packed in any sirup or slightly sweetened water (ounces)
LL Xd LL Xd
No. 303 (303 × 406) 10.7 11.0 9.9 10.2
No. 303 Cylinder (303 × 509) 14.0 14.4 12.7 13.1
No. 2 (307 × 409) 13.1 13.5 12.3 12.7
No. 10 (603 × 700) 71.2 72.0 69.4 70.2
Expand Table

Table II - Single Sampling Plans and Acceptance Numbers

Sample Size (No. of sample containers) 3 6 13 21 29 38 48 60
Acceptance numbers 0 1 2 3 4 5 6 7

(2) Definitions.

Expand Table
Subgroup A group of sample containers representing a portion of a sample.
X′min A specified minimum lot average fill weight.
LWLx Lower warning limit for subgroup averages.
LRLx Lower reject limit for subgroup averages.
LWL Lower warning limit for individual fill weight measurements.
LRL Lower reject limit for individual fill weight measurements.
R′ A specified average range value.
Rmax A specified maximum range for subgroups.

(3) Method for ascertaining fill weight. The fill weight of canned red tart pitted cherries is determined in accordance with the U.S. Standards for Inspection by Variable and the U.S. Standards for Determination of Fill Weights.

(4) Compliance with recommended fill weights. Compliance with the recommended fill weights for canned red tart pitted cherries shall be in accordance with the U.S. Standards for Inspection by Variables and the U.S. Standards for Determination of Fill Weights.

Expand Table

Table III - Recommended Fill Weight Values for Canned Red Tart Pitted Cherries

Container designation Fill weight values in ounces
X′min LWLx LRLx LWL LRL R′ Rmax Sampling allowance code
No. 303 12.9 12.6 12.4 12.2 11.8 0.80 1.70 F
No. 303 Cylinder 16.8 16.4 16.2 15.9 15.4 1.10 2.20 H
No. 2 15.8 15.4 15.2 14.9 14.4 1.10 2.20 H
No. 10 86.7 85.9 85.5 85.0 84.1 2.00 4.20 P


Download our app to see the most-to-date content.