Section 11F. (a) The department shall establish a renewable energy portfolio standard for all retail electricity suppliers selling electricity to end-use customers in the commonwealth. By December 31, 1999, the department shall determine the actual percentage of kilowatt-hours sales to end-use customers in the commonwealth which is derived from existing renewable energy generating sources. Every retail supplier shall provide a minimum percentage of kilowatt-hours sales to end-use customers in the commonwealth from Class I renewable energy generating sources, according to the following schedule: (1) an additional 1 per cent of sales by December 31, 2003, or 1 calendar year from the final day of the first month in which the average cost of any renewable technology is found to be within 10 per cent of the overall average spot-market price per kilowatt-hour for electricity in the commonwealth, whichever is sooner; (2) an additional one-half of 1 per cent of sales each year thereafter until December 31, 2009; (3) an additional 1 per cent of sales each year thereafter until December 31, 2019; (4) an additional 2 per cent of sales each year thereafter until December 31, 2029; and (5) an additional 1 per cent of sales every year thereafter. Any electric load served under a retail electricity supply contract executed or extended not later than December 31, 2018, shall be exempt from any incremental compliance obligation under this section that occurs as a result of an increase or a new requirement imposed on or after January 1, 2019 on the minimum percentage of kilowatt-hour sales to end-use customers that must be derived from Class I RPS eligible resources. For the purpose of this subsection, a new renewable energy generating source is one that begins commercial operation after December 31, 1997, or that represents an increase in generating capacity after December 31, 1997, at an existing facility. Commencing on January 1, 2009, such minimum percentage requirement shall be known as the ''Class I'' renewable energy generating source requirement.
(b) For the purposes of this subsection, a renewable energy generating source is one which generates electricity using any of the following: (1) solar photovoltaic or solar thermal electric energy; (2) wind energy; (3) ocean thermal, wave or tidal energy; (4) fuel cells utilizing renewable fuels; (5) landfill gas; (6) waste-to-energy which is a component of conventional municipal solid waste plant technology in commercial use; (7) naturally flowing water and hydroelectric; (8) low emission advanced biomass power conversion technologies using fuels such as wood, by-products or waste from agricultural crops, food or animals, energy crops, biogas, liquid biofuel including but not limited to biodiesel, organic refuse-derived fuel, or algae; or (9) geothermal energy; provided, however, that the calculation of a percentage of kilowatt-hours sales to end-use customers in the commonwealth from new renewable generating sources shall exclude clause (6). The department may also consider any previously operational biomass facility retrofitted with advanced conversion technologies as a renewable energy generating source. A renewable energy generating source may be located behind the customer meter within the ISO–NE, as defined in section 1 of chapter 164, control area if the output is verified by an independent verification system participating in the New England Power Pool Generation Information System, in this section called NEPOOL GIS, accounting system and approved by the department.
(c) New renewable energy generating sources meeting the requirements of this subsection shall be known as Class I renewable energy generating sources. For the purposes of this subsection, a Class I renewable energy generating source is one that began commercial operation after December 31, 1997, or represents the net increase from incremental new generating capacity after December 31, 1997 at an existing facility, where the facility generates electricity using any of the following: (1) solar photovoltaic or solar thermal electric energy; (2) wind energy; (3) ocean thermal, wave or tidal energy; (4) fuel cells utilizing renewable fuels; (5) landfill gas; (6) energy generated by new hydroelectric facilities, or incremental new energy from increased capacity or efficiency improvements at existing hydroelectric facilities; provided, however, that (i) each such new facility or increased capacity or efficiency at each such existing facility must meet appropriate and site-specific standards that address adequate and healthy river flows, water quality standards, fish passage and protection measures and mitigation and enhancement opportunities in the impacted watershed as determined by the department in consultation with relevant state and federal agencies having oversight and jurisdiction over hydropower facilities; (ii) only energy from new facilities having a capacity up to 30 megawatts or attributable to improvements that incrementally increase capacity or efficiency by up to 30 megawatts at an existing hydroelectric facility shall qualify; and (iii) no such facility shall involve pumped storage of water or construction of any new dam or water diversion structure constructed later than January 1, 1998; (7) low emission advanced biomass power conversion technologies using fuels such as wood, by-products or waste from agricultural crops, food or animals, energy crops, biogas, liquid biofuel including but not limited to biodiesel, organic refuse-derived fuel, or algae; (8) marine or hydrokinetic energy as defined in section 3; or (9) geothermal energy. A Class I renewable generating source may be located behind the customer meter within the ISO–NE control area if the output is verified by an independent verification system participating in the NEPOOL GIS accounting system and approved by the department.
(d) Every retail electric supplier providing service under contracts executed or extended on or after January 1, 2009, shall provide a minimum percentage of kilowatt-hour sales to end-use customers in the commonwealth from Class II renewable energy generating sources. For the purposes of this section, a Class II renewable energy generating source is one that began commercial operation before December 31, 1997 and generates electricity using any of the following: (1) solar photovoltaic or solar thermal electric energy; (2) wind energy; (3) ocean thermal, wave or tidal energy; (4) fuel cells utilizing renewable fuels; (5) landfill gas; (6) energy generated by existing hydroelectric facilities, provided that such existing facility shall meet appropriate and site-specific standards that address adequate and healthy river flows, water quality standards, fish passage and protection measures and mitigation and enhancement opportunities in the impacted watershed as determined by the department in consultation with relevant state and federal agencies having oversight and jurisdiction over hydropower facilities; and provided further, that only energy from existing facilities up to 7.5 megawatts shall be considered renewable energy and no such facility shall involve pumped storage of water nor construction of any new dam or water diversion structure constructed later than January 1, 1998; (7) waste-to-energy which is a component of conventional municipal solid waste plant technology in commercial use; (8) low emission advanced biomass power conversion technologies using fuels such as wood, by-products or waste from agricultural crops, food or animals, energy crops, biogas, liquid biofuel including but not limited to biodiesel, organic refuse-derived fuel, or algae; (9) marine or hydrokinetic energy as defined in section 3; or (10) geothermal energy. A facility in clause (7) shall not be a Class II renewable generating source unless it operates or contracts for one or more recycling programs approved by the department of environmental protection. At least 50 per cent of any revenue received by the facility through the sale of Massachusetts RPS–eligible renewable energy certificates shall be allocated to such recycling programs. A Class II renewable generating source may be located behind the customer meter within the ISO–NE control area provided that the output is verified by an independent verification system participating in the NEPOOL GIS accounting system and approved by the department.
(e) Every retail supplier shall annually provide to end-use customers in the commonwealth generation attributes from Class II energy facilities in an amount approved by the department; provided, however, that the department shall specify that a certain percentage of these requirements shall be met through energy generated from a specific technology or fuel type in subsection (d). Such minimum percentage requirement for kilowatt-hour sales from Class II energy generating sources may be adjusted by the department as necessary to promote the continued operation of existing energy generating resources that meet the requirements of said subsection (d), and may be met through kilowatt-hour sales to end-use customers from any energy generating source meeting the requirements of said subsection (d).
(f) After conducting administrative proceedings, the department may add technologies or technology categories to any list; provided, however, that the following technologies shall not be considered renewable energy supplies: coal, oil, natural gas and nuclear power. The department shall establish and maintain regulations allowing for a retail supplier to discharge its obligations under this section by making an alternative compliance payment in an amount established by the department for Class I and Class II renewable energy generating sources. The department shall establish and maintain regulations outlining procedures by which each retail supplier shall annually submit for the department's review a filing illustrating the retail supplier's compliance with the requirements of this section.
(g) In satisfying its annual obligations under subsection (a), each retail supplier shall provide a portion of the required minimum percentage of kilowatt-hours sales from new on-site renewable energy generating sources located in the commonwealth and having a power production capacity of not more than 6 megawatts which began commercial operation after December 31, 2007, including, but not limited to, behind the meter generation and other similar categories of generation determined by the department. The portion of the required minimum percentage required to be supplied by such on-site renewable energy generating sources shall be established by the department; provided, however, that the department may specify that a certain percentage of these requirements shall be met through energy generated from a specific technology or fuel type.
(h) The department shall adopt regulations allowing for a retail supplier to discharge its obligations under subsection (g) by making an alternative compliance payment in an amount established by the department; provided, however, that the department shall set on-site generation alternative compliance payment rates at levels that shall stimulate the development of new on-site renewable energy generating sources.
(i) A municipal lighting plant shall be exempt from the obligations under this section so long as and insofar as it is exempt from the requirements to allow competitive choice of generation supply under section 47A of chapter 164.