In addition to the information required by § 98.3(c), each annual report must contain the information specified in paragraphs (a) through (e) of this section, as applicable:
(a) Annual facility ferroalloy product production capacity (tons).
(b) If a CEMS is used to measure CO2 emissions, report the annual production for each ferroalloy product identified in § 98.110, from each EAF (tons).
(c) Total number of EAFs at facility used for production of ferroalloy products.
(d) If a CEMS is used to measure CO2 emissions, then you must report under this subpart the relevant information required by § 98.36 for the Tier 4 Calculation Methodology and the following information specified in paragraphs (d)(1) through (d)(3) of this section.
(1) Annual process CO2 emissions (in metric tons) from each EAF used for the production of any ferroalloy product identified in § 98.110.
(2) Annual process CH4 emissions (in metric tons) from each EAF used for the production of any ferroalloy listed in Table K-1 of this subpart (metric tons).
(3) Identification number of each EAF.
(e) If a CEMS is not used to measure CO2 process emissions, and the carbon mass balance procedure is used to determine CO2 emissions according to the requirements in § 98.113(b), then you must report the following information specified in paragraphs (e)(1) through (e)(7) of this section.
(1) Annual process CO2 emissions (in metric tons) from each EAF used for the production of any ferroalloy identified in § 98.110 (metric tons).
(2) Annual process CH4 emissions (in metric tons) from each EAF used for the production of any ferroalloy listed in Table K-1 of this subpart.
(3) Identification number for each material.
(4)-(5) [Reserved]
(6) List the method used for the determination of carbon content for each material included for the calculation of annual process CO2 emissions for each EAF (e.g., supplier provided information, analyses of representative samples you collected).
(7) If you use the missing data procedures in § 98.115(b), you must report how monthly mass of carbon-containing inputs and outputs with missing data was determined and the number of months the missing data procedures were used.
[74 FR 56374, Oct. 30, 2009, as amended at 75 FR 66462, Oct. 28, 2010; 78 FR 71954, Nov. 29, 2013; 79 FR 63785, Oct. 24, 2014]