What test methods and other procedures must I use to establish and demonstrate initial compliance with the operating limits?

  1. Law
  2. CFR 40
  3. Protection of Environment
  4. Environmental Protection Agency
  5. Air Programs
  6. National Emission Standards for Hazardous Air Pollutants for Source Categories
  7. National Emissions Standards for Hazardous Air Pollutants for Primary Magnesium Refining
  8. Initial Compliance Requirements
  9. What test methods and other procedures must I use to establish and demonstrate initial compliance with the operating limits?

Checkout our iOS App for a better way to browser and research.

§ 63.9916 What test methods and other procedures must I use to establish and demonstrate initial compliance with the operating limits?

For a wet scrubber subject to operating limits for pressure drop and scrubber water flow rate in § 63.9890(b), you must establish site-specific operating limits according to the procedures in paragraphs (a) and (b) of this section.

(a) Using the continuous parameter monitoring system (CPMS) required in § 63.9920, measure and record the pressure drop and scrubber water flow rate at least every 15 minutes during each run of the particulate matter performance test.

(b) Compute and record the average pressure drop and scrubber water flow rate for each individual test run. Your operating limits are the lowest average individual pressure drop and scrubber water flow rate values in any of the three runs that meet the applicable emission limit.


Download our app to see the most-to-date content.