(a) Scope and frequency. If you measure ethanol or methanol using a photoacoustic analyzer, verify the amount of H₂O, CO, and CO₂ interference after initial analyzer installation and after major maintenance.

(b) Measurement principles. H₂O, CO, and CO₂ can positively interfere with a photoacoustic analyzer by causing a response similar to ethanol or methanol. If the photoacoustic analyzer uses compensation algorithms that utilize measurements of other gases to meet this interference verification, simultaneously conduct these other measurements to test the compensation algorithms during the analyzer interference verification.

(c) System requirements. Photoacoustic analyzers must have combined interference that is within (0.0 ±0.5) µmol/mol. We strongly recommend a lower interference that is within (0.0 ±0.25) µmol/mol.

(d) Procedure. Perform the interference verification by following the procedure in § 1065.375(d), comparing the results to paragraph (c) of this section.