Drainage system.

  1. Law
  2. CFR 24
  3. Housing and Urban Development
  4. Regulations Relating to Housing and Urban Development
  5. Office of Assistant Secretary for Housing - Federal Housing Commissioner, Department of Housing and Urban Development
  6. Model Manufactured Home Installation Standards
  7. Ductwork and Plumbing and Fuel Supply Systems
  8. Drainage system.

Checkout our iOS App for a better way to browser and research.

§ 3285.604 Drainage system.

(a) Crossovers. Multi-section homes with plumbing in more than one section require drainage system crossover connections to join all sections of the home. The crossover design requirements are located in, and must be designed in accordance with, § 3280.610 of this chapter.

(b) Assembly and support. If portions of the drainage system were shipped loose because they were necessary to join all sections of the home and designed to be located underneath the home, they must be installed and supported in accordance with § 3280.608 of this chapter.

(c) Proper slopes. Drains must be completed in accordance with § 3280.610 of this chapter.

(1) Drain lines must not slope less than one-quarter inch per foot, unless otherwise noted on the schematic diagram, as shown in Figure to § 3285.604.

(2) A slope of one-eight inch per foot may be permitted when a clean-out is installed at the upper end of the run.

(d) Testing procedures. The drainage system must be inspected and tested for leaks after completion at the site. The installation instructions must provide testing requirements that are consistent with § 3280.612 of this chapter.


Download our app to see the most-to-date content.